Trimming knowledge of stainless steel camlock coupling seal

The edge of the seal will bring some rubber burrs when stainless steel camlock coupling produced, these burrs not only affect the quality of the product,but also affect its performance. Frozen trimming is an effective way to trim the flexible rubber joint seal. This method is to be flexible rubber joints into the drum cooling trimming machine, in a certain low temperature conditions, the product burr edge was cold-like, while the rubber joint body remains a certain degree of flexibility. With the operation of the drum, abrasive continuous impact grinding, shot down can be bent rubber glitches, after the completion of the work of the product at room temperature gradually warming, restore flexibility, finishing through the completion of finishing. But to be frozen and trimmed products of its waste side is a certain technical requirements.
1.Thickness of stainless steel camlock coupling should below 0.08 mm, the maximum can not exceed 0.1 mm. But the finished part of the burr of the root of the burr due to the mold with sandpaper cleaning mold cavity, the edge of the tilt angle and the formation of flange-like products, even if the outer edge of the waste side in this range does not meet the refrigeration requirements of the process.
2.Stainless steel camlock coupling can be flexible rubber joints in the multi-mode hole model if the vulcanization into a block, you can not put into the freezer, you must one by one cut, tear, within the hole burr, waste To give up, so that the impact of low temperature to shorten the time, dressing effect will be better.